Product Description
4-position in-line Metri-Pack connector used on all Electromotive 4- and 6-cylinder DFUs. Connector comes with the appropriate pins and seals to accommodate the larger 16 AWG wire of the DFU wires.
At this point in time, Electromotive is not selling or repairing product. If you have a serious interest in purchasing the rights and technology of the Electromotive product line as well as its sale channels, including all of our website names, please contact tech@electromotive-inc.com. Thank you for your understanding and support.
Electromotive DFU Connector
$9.00
- 4-position Metri-Pack connector
- 5 Metri-Pack terminals
- 1 Metri-Pack seal
Related Products
-
DFU Cable and Connector 6′
6′ 16 AWG 3-conductor shielded wire for use with XDi and TEC wire harnesses. Includes terminated AMP terminals on one end and 4-position DFU connector on the other end.
-
Cable and Connector for 1 Bar MAP Sensor
6′ 3-wire cable and terminated connector for use with GM-style 1 bar MAP sensor. This cable and connector can be used to repair a damaged harness or to extend the length of an unterminated harness. It can also be used when terminating the connector pins directly to the harness is not desired or possible.
-
Knock Sensor Connector, Pins and Seal
Gray single-pin Weather Pack connector, pins and seal for early GM knock sensor.
-
GM Shaft-Style TPS Cable and Connector
3-position circular male Metri-Pack connector for use with GM shaft-style TPS sensors.