Installation Supplies
Electromotive has assembled many of the supplies needed to properly complete an installation, including TXL wire, loom, connectors, relays, etc.
-
5-Position Relay Socket
Relay socket and terminals for installing standard 5-position SPDT relays. This is for the socket only, and does not include the relay itself. Relay mounting socket has interlocking provisions. This is the same socket used in the Electromotive Power Fuse and Relay harness (PN 070-40000).
-
Relay Kit, SPDT 40/60A
SPDT (5-position) Bosch-style relay kit. This relay kit includes a 40/60A relay, mounting socket and small and large wire gauge terminals. Relay mounting socket has interlocking provisions. This is the same relay and socket used in the Electromotive Power Fuse and Relay harness (PN 070-40000).
-
23 Pin AMP Connector Strain Relief
This strain relief mounts to the 23 pin AMP connectors used on Electromotive XDI, XDI2, TECs, TEC3 and TEC3r systems. It provides protection for the wires at the point of entry into the connector.
-
Dual-Wall Heat Shrink Kit-3:1 Shrink Ratio-Black
53 pieces of assorted diameter black heat shrink. Heat shrink is dual-wall adhesive lined for optimal wire protection.
-
Dual-Wall Heat Shrink Kit-3:1 Shrink Ratio-Red
53 pieces of assorted diameter red heat shrink. Heat shrink is dual-wall adhesive lined for optimal wire protection.
-
35 Pin AMP Connector Strain Relief
This strain relief mounts to the 35 pin AMP connectors used on Electromotive TECgt and TEC EVO systems. It provides protection for the wires at the point of entry into the connector.
-
TEC Fuse and Relay Harness
Fuse and relay harness used for all TEC systems. This fuse and relay harness includes a fuses and relays for the TEC ECU, coils, injectors and fuel pump pre-wired and ready to integrate with our flying lead harnesses.
-
Firewall Boot
This rubber firewall pass-through boot has a selectable outlet diameter so that it can accommodate different size harnesses.
-
Weather-Pack 22-Pin Bulkhead Connector Kit
This Delphi WeatherPack bulkead connector is an inexpensive and reliable way to add a quick-disconnect to your ECU install.
-
Weather-Pack Starter Kit
The WeatherPack starter kit contains an assortment of WeatherPack male and female connector pairs.