Product Description
3-position circular male Metri-Pack connector for use with GM shaft-style TPS sensors.
3-position circular male Metri-Pack connector for use with GM shaft-style TPS sensors.
6′ 3-wire cable and terminated connector for use with GM-style 1 bar MAP sensor. This cable and connector can be used to repair a damaged harness or to extend the length of an unterminated harness. It can also be used when terminating the connector pins directly to the harness is not desired or possible.
Single-pin Weather Pack connector with 6′ of lead for early GM single-wire knock sensor. For repairing a damaged harness or where terminating connector is not desired.
4-position in-line Metri-Pack connector used on all Electromotive 4- and 6-cylinder DFUs. Connector comes with the appropriate pins and seals to accommodate the larger 16 AWG wire of the DFU wires.
2-position Weather Pack connector kit. Can be used to replace damaged connector or for general wiring projects that require a 2-position connect/disconnect point.