Product Description
CAN breakout cable for use with all CAN-equipped TEC units with DB9 serial ports.
At this point in time, Electromotive is not selling or repairing product. If you have a serious interest in purchasing the rights and technology of the Electromotive product line as well as its sale channels, including all of our website names, please contact tech@electromotive-inc.com. Thank you for your understanding and support.
TEC CAN Cable
$49.00
- Allows CAN-equipped TEC units with DB9 serial ports to be connected to compatible CAN-supported devices, such as displays and data-logging equipment
- Must be in place when CAN output on unit is enabled to prevent communications issues through DB9 cable
- NOT COMPATIBLE WITH XDi2 SYSTEM!
Related Products
-
DFU Cable and Connector 6′
6′ 16 AWG 3-conductor shielded wire for use with XDi and TEC wire harnesses. Includes terminated AMP terminals on one end and 4-position DFU connector on the other end.
-
Knock Sensor Connector, Pins and Seal
Gray single-pin Weather Pack connector, pins and seal for early GM knock sensor.
-
TEC3 Basic Sensor Connector Set
This kit includes the connectors, pins and seals used on GM sensors most commonly used in aftermarket EFI retrofitting. These include the connectors for the MAP, TPS, coolant, MAT, knock, IAC and HEGO. The kit also includes 2 DFU connectors.
-
1-Position Weather Pack Connector Kit
1-position Weather Pack connector kit. Can be used to replace damaged connector or for general wiring projects that require a 1-position disconnect point.