Product Description
9-pin serial cable for connecting early “gold”-era Electromotive units to a 9-pin serial port-equipped laptop or serial adapter.
At this point in time, Electromotive is not selling or repairing product. If you have a serious interest in purchasing the rights and technology of the Electromotive product line as well as its sale channels, including all of our website names, please contact tech@electromotive-inc.com. Thank you for your understanding and support.
TECI, TECII and HPV3-B Serial Cable
$49.00
6′ cable with DB9 serial port on one end and RX, TX and ground leads at the other end
Related Products
-
DFU Cable and Connector 6′
6′ 16 AWG 3-conductor shielded wire for use with XDi and TEC wire harnesses. Includes terminated AMP terminals on one end and 4-position DFU connector on the other end.
-
Cable and Connector for 1 Bar MAP Sensor
6′ 3-wire cable and terminated connector for use with GM-style 1 bar MAP sensor. This cable and connector can be used to repair a damaged harness or to extend the length of an unterminated harness. It can also be used when terminating the connector pins directly to the harness is not desired or possible.
-
Knock Sensor Connector, Pins and Seal
Gray single-pin Weather Pack connector, pins and seal for early GM knock sensor.
-
GM Early-Style TPS Cable and Connector
Pre-terminated cable and connector for early GM arm-style TPS sensors. Also for use with Electromotive Ford and JFI TPS sensors. For use in harness repairs or when terminating the connector to the wires is not desired.