Skip to content
  • Cart
  • My Account
Electromotive
  • Our Products
  • Support
  • Online Store
  • Dealers
  • About
  • Cart
  • My Account
Electromotive
  • Clearance
  • TEC Engine Management Systems
  • XDi Ignition Systems
  • Plug-And-Play Systems
    • BMW E36 PNP ECU
    • Mazda Miata Plug-and-Play Kits
  • Ignition Coils
  • Crank & Cam Trigger Solutions
    • Trigger Kits
    • Trigger Wheels
    • Crank & Cam Sensor Brackets
    • Crank & Cam Sensors
  • Wire Harnesses
    • Terminated Harnesses
    • Unterminated Harnesses
    • Harness Connector and Pin Sets
  • Accessories
    • Accessory Modules
    • Fuel Components
  • Sensors and Connectors
    • Engine Sensors
    • Cables and Connectors
  • Tools and Supplies
    • Installation Tools
    • Installation Supplies
  • The Workshop
    • Intakes and Throttle Bodies
    • Fuel Delivery
    • Miscellaneous
  • Engineering Services
  • Electromotive Gear
    • Gear
    • Decals & Banners
Electromotive / Products / Crank & Cam Trigger Solutions / Crank & Cam Sensors / 1/2″ Hall Effect Crank Sensor
260-75000

1/2″ Hall Effect Crank Sensor

$149.00

Available on backorder

SKU: 260-75000. Category: Crank & Cam Sensors.
  • Description
  • Features
  • Specs
  • Downloads

Product Description

1/2″ diameter smooth bore Hall effect crank sensor. This sensor is directly interchangeable with the standard 1/2″ magnetic crank sensor. This sensor can be used on any Hall effect-compatible Electromotive systems and will work on trigger wheels 3″ or larger. Hall effect crank sensors can often be used to address noise related starting/running issues, as they tend to be less susceptible to interference. Sensors have necessary pull-up resistor in place.

  • 1/2″ smooth-bore sensor body
  • 6′ Santoprene jacketed 2-wire + shield cable
  • Male and female connectors, pins and seals
  • Built in pull-up resistor

Related Products

  • 1/2″ Magnetic Crank Sensor

    1/2” magnetic crank sensor for use with all Electromotive systems. Can be used with trigger wheels 3” or larger. Should not be used as a cam trigger.

  • Crank Trigger Simulator

    The Crank Trigger Simulator creates a variable RPM Signal in a 60-2 pattern. Allows for running Electromotive TEC and XDi systems without the engine running. This is beneficial for calibrating the XDi’s manual potentiometers, as well as general system testing on any unit. Also provides a cam pulse for testing sequential injection functionality on TEC […]

  • 3/8″ Chisel Point Magnetic Sensor

    3/8″ chisel point magnetic sensor for use with all Electromotive systems. The 3/8″ chisel point sensor features a fine chisel point exposed sensor element for use with small-diameter, fine-pitch trigger wheels. It should be used with 60-2 trigger wheels under 3″ and all camshaft speed wheels. It can also be used to replace early flat […]

  • Y Cable Assembly

    Y cable assembly allows for a single-crank sensor’s signal to be split to two systems. This is commonly used on legacy systems such as the HPV and HPX when used in a dual-plug configuration. It is used in conjunction with the 3/8″ or 1/2″ sensors to replace early Y cable sensors.


© 2015 ELECTROMOTIVE
  • Privacy Policy
  • Terms of Use
  • Sitemap
  • Employment
  • Contact Us
LinkedIn