Online Store

At this point in time, Electromotive is not selling or repairing product. If you have a serious interest in purchasing the rights and technology of the Electromotive product line as well as its sale channels, including all of our website names, please contact tech@electromotive-inc.com. Thank you for your understanding and support.
  • Cable and Connector for 1 Bar MAP Sensor

    6′ 3-wire cable and terminated connector for use with GM-style 1 bar MAP sensor. This cable and connector can be used to repair a damaged harness or to extend the length of an unterminated harness. It can also be used when terminating the connector pins directly to the harness is not desired or possible.

  • TEC3r

    The TEC3r represents the current top-of-the-line Electromotive system.

    All Electromotive engine and/or ignition units may only be purchased through Dealers. Please click here to find a dealer.

  • TEC3r 12′ Unterminated Harness

    12′ unterminated “Flying Lead” harness for TEC3r ECU

  • TECgt Plug and Play Kit for MX5 Miata

    Developed together with top Miata race engine and car builder Jesse Prather of Jesse Prather Motorsports, the Electromotive MX5 Miata Plug and Play kits make the installation of an Electromotive TECs or TECgt something most do-it-yourselfers can handle.

  • Toyota 4AG/MR2 1st Gen Trigger Kit

    Crank trigger kit for the 1st Gen Toyota MR2 and other 4AG-equipped vehicles.

  • XDi200 8′ Unterminated Harness

    8′ replacement harness for the XDi200 ignition system.  This harness is needed when the harness included with the XDi200 is unavailable, damaged or needs to be replaced.

  • 1/2″ Hall Effect Crank Sensor

    1/2″ diameter smooth bore Hall effect crank sensor. This sensor is directly interchangeable with the standard 1/2″ magnetic crank sensor. This sensor can be used on any Hall effect-compatible Electromotive systems and will work on trigger wheels 3″ or larger. Hall effect crank sensors can often be used to address noise related starting/running issues, as […]

  • 2 and 3 Bar MAP Connector

    Weather Pack connector for GM 2 and 3 bar MAP sensors (early style). Includes 4 pins and seals for terminating to harness.

  • 3 Bar MAP Sensor

    GM-style 3 bar MAP sensor. This sensor is used to determine engine load on forced induction engines. This sensor is intended to be used on engines producing positive manifold pressure up to 2 bar, or roughly 30psi of boost. This sensor is not recommended for use with engines that will not see boost above 1 […]

  • Add 15 Minutes Technical Assistance

    Purchase additional tech support time in 15 minute increments.