Online Store

At this point in time, Electromotive is not selling or repairing product. If you have a serious interest in purchasing the rights and technology of the Electromotive product line as well as its sale channels, including all of our website names, please contact tech@electromotive-inc.com. Thank you for your understanding and support.
  • Single-Tower Ignition Coil

    The Electromotive single-tower ignition coil for use with all TEC or XDi systems.

  • TEC3r and 6/12 AMP Connector Kit

    TEC3r and 6/12 AMP connector kit consists of the 2 23-pin AMP connectors used on the harness side of the TEC3r and 6/12 units. These connectors can be purchased as replacements for worn or damaged connectors, or when building harnesses from scratch. Includes 50 AMP seal terminals.

  • TECgt200

    The TECgt200 sits at the top of the 200-series line and was designed as an extremely flexible engine management system – able to run up to 12 cylinder engines with ease.

    All Electromotive engine and/or ignition units may only be purchased through Dealers. Please click here to find a dealer.

  • TECgt200 8′ Unterminated Harness

    8′ unterminated “Flying Lead” harness for TECgt200 ECU

  • Toyota MR2 Turbo Crank Trigger Kit

    Crank trigger kit for the 2nd Gen 1991-1993 Toyota MR2 Turbo 3SGTE engine.

  • Cable and Connector for 2 and 3 Bar MAP Sensor

    6′ 3-wire cable and terminated connector for use with early GM 2 and 3 bar MAP sensors. This cable and connector can be used to repair a damaged harness or to extend the length of an unterminated harness. It can also be used when terminating the connector pins directly to the harness is not desired […]

  • Dual-Tower Ignition Coil

    Replacement dual-tower coil for Electromotive systems.

  • Hall Effect Cam Trigger w/ Pull-Up Resistor

    Threaded body Hall effect cam sensor. For use with custom cam trigger setups; includes pre-installed pull-up resistor.

  • Small Block Chevy 7.25″ Trigger Kit

    Allows for a 60-2 trigger wheel to be mounted between the pulley and damper of Small Block Chevys equipped with up to a 7″ damper. Sensor bracket mounts in the stock timing pointer location. Stamped timing pointer can be retained.

  • TEC3 Standard AMP Connector Kit

    TEC3 standard AMP connector kit consists of the 2 23-pin AMP connectors used on the harness side of the TEC3. These connectors can be purchased as replacements for worn or damaged connectors, or when building harnesses from scratch. Includes 50 AMP seal terminals.