$199.00
For converting a 2-wire IAC driver signal to a 3-wire signal.
For converting a 2-wire IAC driver signal to a 3-wire signal. For use with any Electromotive system with a 2-wire IAC output. (As of software version 4.10, TECs and TECgt units do not need this adapter unless only one GPO can be afforded IAC output status. All TEC3r units need this adapter for 3-wire support.)
CAN breakout cable for use with all CAN-equipped TEC units with DB9 serial ports.
Switching box for toggling between primary and auxiliary crank position sensors. Designed for use with XDi and earlier HPX ignition systems.
Remote mount timing retard module for use with Electromotive products. Module can be connected to a toggle or momentary switch to produce an instant timing shift of -1 to -12 degrees. It can also be used with a relay and be triggered by a nitrous solenoid, high-gear switch or any other trigger.
The Start Assist System allows a standard 12V charging system to charge a second 6 or 12V battery that has been installed in series between the primary battery and the starter motor.