Product Description
Threaded body Hall effect cam sensor. For use with custom cam trigger setups; includes pre-installed pull-up resistor.
Threaded body Hall effect cam sensor. For use with custom cam trigger setups; includes pre-installed pull-up resistor.
3/8″ chisel point magnetic sensor for use with all Electromotive systems. The 3/8″ chisel point sensor features a fine chisel point exposed sensor element for use with small-diameter, fine-pitch trigger wheels. It should be used with 60-2 trigger wheels under 3″ and all camshaft speed wheels. It can also be used to replace early flat […]
Y cable assembly allows for a single-crank sensor’s signal to be split to two systems. This is commonly used on legacy systems such as the HPV and HPX when used in a dual-plug configuration. It is used in conjunction with the 3/8″ or 1/2″ sensors to replace early Y cable sensors.
Cable for adapting 3-position Weather Pack crank sensor plug to the 2-wire GM Ecotec block-mounted crank sensor. For use only with GM engines running 58-tooth trigger wheels. *Note: GM engines do not use the 11th tooth for TDC reference. Always verify tooth location at TDC and compensate in your timing tables/knobs.
Universal cam trigger kit allows the addition of a cam reference on engines not equipped with one. A cam reference is necessary if sequential injection firing is desired. The kit includes 2.5″ mild steel cam trigger wheel with 10mm I.D. and threaded body Hall effect cam sensor.