Product Description
GM single-wire knock sensor. Sensor features a 1/4″ NPT thread for block mounting. May require block threading to install. Compatible with all knock input-equipped Electromotive systems.
At this point in time, Electromotive is not selling or repairing product. If you have a serious interest in purchasing the rights and technology of the Electromotive product line as well as its sale channels, including all of our website names, please contact tech@electromotive-inc.com. Thank you for your understanding and support.
Knock Sensor
$66.00
- Knock sensor with 1/8″ NPT thread
- 1-pin Weather Pack connector
- 2 male Weather Pack terminals
- 2 Weather Pack seals
Related Products
-
1 Bar MAP Sensor
GM-style 1 bar MAP sensor. This sensor is used to determine engine load on naturally aspirated engines. Can also be used as an external barometric correction sensor. Sensor features vacuum port, mounting tabs and necessary connector, pins and seals for terminating harness.
-
2 Bar MAP Sensor
GM-style 2 bar MAP sensor. This sensor is used to determine engine load on forced induction engines. This sensor is intended to be used on engines producing positive manifold pressure up to 1 bar, or roughly 15psi of boost. Sensor features vacuum port, mounting tabs and necessary connector, pins and seals for terminating harness.
-
3 Bar MAP Sensor
GM-style 3 bar MAP sensor. This sensor is used to determine engine load on forced induction engines. This sensor is intended to be used on engines producing positive manifold pressure up to 2 bar, or roughly 30psi of boost. This sensor is not recommended for use with engines that will not see boost above 1 […]
-
EGO Boss – Weld-In
A weld-in boss for EGO/HEGO sensors for retrofit or installation into custom exhaust systems.